Surface Resistance Meter Kit

The Surface Resistance Meter Kit (or its Meter) is referenced and designed to be used to make Resistance Measurements.

Specification

Resistance measurement accuracy of ±10% (±20% for resistance values 1 x 1011 and greater).
Resistance range of <1 x 103 ohms to >1 x 1012 ohms.
Under load voltages of 10 and 100 volts ±5%.
Electrification period of approximately 15 seconds.

Features

• NEW Enclosure with Rubber Grip Edges Thinner and narrower design is easier to hold and provides protection from drops.
• NEW Quick Check Button Bypasses the 15 second electrification period to allow quick spot checks.
• NEW Battery Compartment Easy-to-access compartment without the need for tooling or probes.
• Digital Compliance Verification Surface Resistance Meter Kit* Measures resistance point-to-point(Rtt) or surface to ground (Rtg) of worksurfaces, flooring systems, garments, packaging, and other materials in accordance with ESD Association documents: ESD TR53, ANSI/ESD S4.1, ANSI/ESD S7.1, ANSI/ESD STM97.1 and other documents.
• Resistance Range: Greater Than 1.0 x 103 ohms to Less Than 1.0 x 1012 (+/-10% Accuracy) Determines if a surface is dissipative, conductive, or insulative for ESD control applications in electronics manufacturing or handling environments.
• Under Load Test Voltages (10V or 100V ±5%) Meets ANSI/ESD S20.20 resistance testing requirements for product qualification and compliance verification.
• Selectable Test Voltage Switches to appropriate test voltage (10V for tests <1 x 106 or 100V for tests >1 x 106) in AUTO mode or may be fixed to at 10V in HOLD mode.
• Ohm Values are Expressed with a Digital Mantissa and LED Exponent Provides an easy to read and accurate measurement.
• Pre-set 15 Second Electrification Period in Full Test Mode Meets the requirements of the ANSI/ESD S4.1 testing requirements.
• Temperature (Fahrenheit and Celsius) and Relative Humidity Measurements Measures temperature and relative humidity (during 15 second electrification period) as required by ANSI/ESD S20.20.
• NIST Calibrated with Certificate Calibrated with accepted procedures and standards traceable to the National Institute of Standards and Technology. For more information on calibration of Desco products, see Calibration.
• Made in the United States of America Made and stocked in Chino, CA.

Option

1 Digital Surface Resistance Meter